Pointix - Integrating Check Point and Zabbix Use this template to monitor Checkpoint firewalls CPU, mem, HA status and FW-1 activity.The following value map must be created for the Checkpoint templates collection :"Checkpoint standard status"0 ⇒ OK1 ⇒ Warning2 ⇒ ErrorThe advsnmp.discovery external script (). Use this template to monitor Checkpoint firewalls interfaces and packet filtering.The following value map must be created for the Checkpoint templates collection :"Checkpoint standard status"0 ⇒ OK1 ⇒ Warning2 ⇒ ErrorThe advsnmp.discovery external script (). Having said that, in case the issue persists please feel free to contact our 24/7 customer support team.Use this template to monitor Checkpoint firewalls VPN activity.The following value map must be created for the Checkpoint templates collection :"Checkpoint standard status"0 ⇒ OK1 ⇒ Warning2 ⇒ ErrorThe advsnmp.discovery external script (). Note: In case you are experiencing different results, make sure that you have you carefully gone through all the steps. Remote subnet and mask (the subnet is used in your local network).Remote gateway/router public IP (must be reachable while connected to the dedicated server).Encryption details (AES, SHA and DH group) - AES256, SHA256 and DH group 14 are recommended (also must support IKEv2).Pre-shared key - you can generate it or we can provide it.In order to finalize the site-to-site setup on our end, please provide these values via Site-to-site request from in the NordLayer Control Panel: Select External (leads out to the internet) Select Network defined by the interface IP and Net MaskĪdd the IP of your NordLayer gateway as IP Address Īdd NordLayer remote subnet 10.6.0.0 as IP Address.Under the General tab, fill in Name, IP Address, and Net Mask Ĭreate a Network group with All local networks to be trusted with the VPN tunnelsĪdding the NordLayer gateway IP and remote subnet.Under Check Point firewall policy, add a rule for any to any, in and out to 10.6.0.0/20 Select OK Additional settings at the Check Point Smart Console.
Set VPN Tunnel Sharing to One VPN tunnel per Gateway pair Please note: Check Point recommends choosing a shared secret that contains at least 20 characters
Add your NordLayer gateway as Center Gateway.Specify an Object Name of your own choice.Please make sure you have the IP of your NordLayer dedicated server Creating a gateway object at the Check Point Smart ConsoleĪdd NordLayer Private Gateway as an object as shown in the image below. Note: If your device/service supports SHA256 and DH group 14, it is recommended to use these settings instead.
0 kommentar(er)
